Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
34
Print direction
AP4.4 AP5.4 AP7.t
[10] Orientation of the printout „Foot first“ (A) or „Head first“ (B).
Foot first (Default) Orientation of the printout according to [10A].
Head first Orientation of the printout according to [10B]. Mind the following:
¯ Define the „true“ label length (without gap length) in parameter
PRINT PARAMETERS > Material length. If the label gap is wider than 5mm, the
parameter
SYSTEM PARAMETERS > Miss. label tol. must be set to a value more than
zero.
¯ The distance between material base line and the first printable dot is
1 mm. To keep this distance while printing „head first“, the material width
must be calculated as follows::
, with
b
Mat
: Material width
b
Bp
: Backing paper width
b
Lab
: Label width
AB
Printer
Printout
b
Mat
b
Bp
1mm–()2 b
Lab
+⋅=