Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
30
P For information on the peripheral driver data on the service status printout
refer to paragraph > MODULE FW VERS.
 on page 111.
Dottest endless
AP4.4 AP5.4 AP7.t
Dottest for application with endless label stock.
This function prints a pattern which enables trained personnel to check the
adjustment as well as the function of the printhead.
Test pattern
The „Dottest endless“ or „Dottest punched“ prints a pattern consisting of 33
rows filled with vertical lines on the upper label area. All lines have a constant
distance of 4 dot. With every new row, the line pattern is shifted one dot. The
resulting line-pattern repeats every four rows.
The test pattern shows missing dots clearly as white vertical lines running
through the pattern.
The lower label area is filled with testpatterns, which are kept close to those
used by Kyocera. The patterns are useful for printout comparison.
The bars underneath the test pattern allow the adjustment of the different
zero lines.
Dottest punched
AP4.4 AP5.4 AP7.t
Dottest for application with punched material.
P See parameter Dottest endless  on page 30.