Service manual

1. Only with PRINT PARAMETERS > Bar code Multi. = „ yes“ 2. Only with BLDC firmware version V4-T36 or higher 4. Only with at least one data block stored in the flash memory 5. Only with rewinder option
6. Only with cutter 7. Only with „AP 5.4 peripheral“ 10. Only with activated MONARCH LANGUAGE INTERPRETER™ 12. Only if PRINT PARAMETERS > Punch mode = Manual 13. Only in production mode
14. As in 13. or with a setting value > 0 18. Only with installed RFID option 20. Only if SYSTEM PARAMETERS > Periph. device = Dispenser 21. Only if SYSTEM PARAMETERS > Periph. device = Int Rewinder
22. Only with an activated RFID option 23. Only with I/O board 24. Not with I/O board 29. Availability depends on device configuration 30. Only with a CF card inserted 31. Only with WLAN CF card inserted
09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
17
AP7.t Parameters
SERVICE DATA
(SERVICE DATA cont.)
> MODULE FW VERS. > CPU BOARD DATA
System version CPU identifier
System revision PCB revision
System date
Bootloader FPGA version
uMon MAC address
Feed driver Serial number
Head driver Production date
Peripheraldriver PCB part number
Board part numb.
> OPERATION DATA
Manufacturer 13
Serv. operations
Work place 13
Headnumber
Company name 13
Roll number
Cutter number 6 > CF CARD SLOT
Head run length Card in slot
Roll run length
Cuts on knife 6 > MEMORY DATA
Tot. mat. length Ram memory size
Tot. foil length Flash mem size
Total cuts 6 Space for Jobs
Total head moves Max. Labellength
Head strobes Default values
Foil diameter
Operation time
> POWERSUPPLYDATA
Type
FW 3.33