Service manual

ManualsBrandsAvery Dennison ManualsBusiness equipmentAP5.6

1. Only with PRINT PARAMETERS > Bar code Multi. = „ yes“ 2. Only with BLDC firmware version V4-T36 or higher 4. Only with at least one data block stored in the flash memory 5. Only with rewinder option

6. Only with cutter 7. Only with „AP 5.4 peripheral“ 10. Only with activated MONARCH LANGUAGE INTERPRETER™ 12. Only if PRINT PARAMETERS > Punch mode = Manual 13. Only in production mode

14. As in 13. or with a setting value > 0 18. Only with installed RFID option 20. Only if SYSTEM PARAMETERS > Periph. device = Dispenser 21. Only if SYSTEM PARAMETERS > Periph. device = Int Rewinder

22. Only with an activated RFID option 23. Only with I/O board 24. Not with I/O board 29. Availability depends on device configuration 30. Only with a CF card inserted 31. Only with WLAN CF card inserted

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters

AP 4.4 – AP 5.4 – AP 7.t

AP7.t Parameters

(SYSTEM PARAM. cont.)

I/O BOARD PARA 23 MLI PARAMETERS 10 TEXTILE PARAMETE SPECIAL FUNCTION SERVICE FUNCTION

Print Info Mode

Start delay 23 Version 10 Changelabel Mode Printer type 13 Service 13

Reprint function

Start print mode 23 Darkness 10 Changelab Print Default values 13 Head exchange 13

Language

Reprint signal 23 Control Prefix 10 Changelab Length Command Sequence 13 Roller exchange 13

Keyboard

Feed 23 Format Prefix 10 Label Eject Mode Delete job Cutter exchange 13+6

Access authoriz.

Pause input 23 Delimiter Char 10 Head lift autom. Delete spooler Serv. data reset 13

Realtime clock

Error output 23 Label Top 10 Head clean Factory settings EasyPlug monitor 13

Error polarity 23 Left Position 10 Parameter to CF EP Monitor Mode 13

Status output 23 Manual Calibrate 10 Data blocks del. 4 Head adjust

Status polarity 23 Resolution 10 System version Sensor adjust 13

End print mode 23 Error Indication 10 EasyPl. file log 30 Sensor test

Error Checking 10 Log files delete 30 Cutter test

305 DPI Scaling 10 Matend adjust

Image Save Path 10 Matend tolerance

Command ^PR 10 Feedadjust label

Command ^MT 10 Feed adjust

Label Invert 10 Punch y calibr. 13

Command ^JM 10 CompactFlashTest

Send test

Receive test

Rewinder adjust 5

Com2 comun. test 23

Com2 port test 23

Print test

FW 3.33