Service manual

1. Only with PRINT PARAMETERS > Bar code Multi. = „ yes“ 2. Only with BLDC firmware version V4-T36 or higher 4. Only with at least one data block stored in the flash memory 5. Only with rewinder option
6. Only with cutter 7. Only with „AP 5.4 peripheral“ 10. Only with activated MONARCH LANGUAGE INTERPRETER™ 12. Only if PRINT PARAMETERS > Punch mode = Manual 13. Only in production mode
14. As in 13. or with a setting value > 0 18. Only with installed RFID option 20. Only if SYSTEM PARAMETERS > Periph. device = Dispenser 21. Only if SYSTEM PARAMETERS > Periph. device = Int Rewinder
22. Only with an activated RFID option 23. Only with I/O board 24. Not with I/O board 29. Availability depends on device configuration 30. Only with a CF card inserted 31. Only with WLAN CF card inserted
09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
15
AP7.t Parameters
AP 7.t Parameter
PRINT INFO PRINT PARAMETERS INTERFACE PARA
(INTERFACE PARA cont.) (INTERFACE PARA cont.)
SYSTEM PARAMETER
Printer status Print speed. >EASYPLUGINTERPR Parity
WLAN 64Bit key 4 31 Foil end warning
Memory status Feed speed. Interface Stop bits
WLAN 128Bit key 1 31 Foil warn stop
Font status Material type Spooler mode Data synch.
WLAN 128Bit key 2 31 Print Interpret.
Flashdata status 4 Material length Printer ID no. Frame error WLAN 128Bit key 3 31 Character sets
Textile care sym Material width Spooler size
WLAN 128Bit key 4 31 Character filter
Service status Print direction Offline mode >CENTRONICS
WLAN com quality 31 Licht sens. type
Dottest endless Punch offset Interface delay PnP function
WLAN signal lev. 31 Head-sensor dist 13/14
Dottest punched Bar code Multi. Sens. punch-LS
Reference Label
Tradit. Imaging 1/13 >COM1 PORT > NETWORK PARAM. > OPTIONS Ribbon autoecon.
UPC plain-copy Baud rate IP Addressassign Remote Display Ribbon eco. limit
EAN Readline No. of data bits IP Address StandAlone Input Feed mode
EAN sep. lines Parity Net mask Turn-on mode
Cut speed. 6 Stop bits Gateway address Error reprint
Cut position 6 Data synch. Port address EasyPlug errors
Double cut 6 Frame error Ethernet speed Single job mode
Rotated barcodes MAC address Head resistance
X – Printadjust
>COM2 PORT 23 SNMP agent Temp. reduction
Y – Printadjust
Baud rate 23 SNMP password 13 Voltage offset
Punch mode
No. of data bits 23 FTP server Miss. label tol.
Punch level 12 Parity 23 FTP password 13 Gap detect mode
Stop bits 23 WEB server Periph. device
Data synch. 23 DHCP host name Singlestartquant
Frame error 23 WLAN SSID 31 External signal
Serial Port Mode 23 WLAN WEP 31 Signal edge 24
WLAN default key 31 Print contrast
>COM3 PORT
WLAN 64Bit key 1 31 Ram disk size
Baud rate
WLAN 64Bit key 2 31 Font downl. area
No. of data bits
WLAN 64Bit key 3 31 Free store size
FW 3.33