Service manual

1. Only with PRINT PARAMETERS > Bar code Multi. = „ yes“ 2. Only with BLDC firmware version V4-T36 or higher 4. Only with at least one data block stored in the flash memory 5. Only with rewinder option
6. Only with cutter 7. Only with „AP 5.4 peripheral“ 10. Only with activated MONARCH LANGUAGE INTERPRETER™ 12. Only if PRINT PARAMETERS > Punch mode = Manual 13. Only in production mode
14. As in 13. or with a setting value > 0 18. Only with installed RFID option 20. Only if SYSTEM PARAMETERS > Periph. device = Dispenser 21. Only if SYSTEM PARAMETERS > Periph. device = Int Rewinder
22. Only with an activated RFID option 23. Only with I/O board 24. Not with I/O board 29. Availability depends on device configuration 30. Only with a CF card inserted 31. Only with WLAN CF card inserted
09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
14
AP 4.4 Parameters
MLI PARAMETERS 10 SPECIAL FUNCTION SERVICE FUNCTION SERVICE DATA
(SERVICE DATA cont.)
Version 10 Command sequence 13 Service 13 > MODULE FW VERS. MAC address
Darkness 10 Default values 13 Head exchange 13 System version Serial number
Control Prefix 10 Delete job Roller exchange 13 System revision Production date
Format Prefix 10 Delete spooler Serv. data reset 13 System date PCB part number
Delimiter Char 10 Factory settings EasyPlug monitor 23 Bootloader Board part numb.
Label Top 10 Parameter to CF EP Monitor Mode 13 uMon Manufacturer 13
Left Position 10 Sensor adjust 13 Work place 13
Manual Calibrate 10 Sensor test > OPERATION DATA Company name 13
Resolution 10 Cutter test Serv. operations
Error Indication 10 Matend adjust Headnumber > CF CARD SLOT
Error Checking 10 Matend tolerance Roll number Card in slot
Image Save Path 10 Feedadust label Head run length
Command ^PR 10 Feed adjust Roll run length > MEMORY DATA
Command ^MT 10 Punch y calibr. 13 Tot. mat. length Ram memory size
Label Invert 10 CompactFlashTest Tot. foil length Flash mem size
Command ^JM 10 Send test Head strobes Space for Jobs
Receive test Head temperature Max. Labellength
Com2 comun. test 23 Foil diameter Default values
Com2 port test 23 Operation time
Print test
> POWERSUPPLYDATA
Type
PS temperature
> CPU BOARD DATA
CPU identifier
PCB revision
FPGA version
FW 3.33