Service manual

ManualsBrandsAvery Dennison ManualsBusiness equipmentAP5.6

1. Only with PRINT PARAMETERS > Bar code Multi. = „ yes“ 2. Only with BLDC firmware version V4-T36 or higher 4. Only with at least one data block stored in the flash memory 5. Only with rewinder option

6. Only with cutter 7. Only with „AP 5.4 peripheral“ 10. Only with activated MONARCH LANGUAGE INTERPRETER™ 12. Only if PRINT PARAMETERS > Punch mode = Manual 13. Only in production mode

14. As in 13. or with a setting value > 0 18. Only with installed RFID option 20. Only if SYSTEM PARAMETERS > Periph. device = Dispenser 21. Only if SYSTEM PARAMETERS > Periph. device = Int Rewinder

22. Only with an activated RFID option 23. Only with I/O board 24. Not with I/O board 29. Availability depends on device configuration 30. Only with a CF card inserted 31. Only with WLAN CF card inserted

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters

AP 4.4 – AP 5.4 – AP 7.t

AP 4.4 Parameters

AP 4.4 Parameter

PRINT INFO PRINT PARAMETERS INTERFACE PARA

(INTERFACE PARA cont.)

SYSTEM PARAMETER (SYSTEM PARAM. cont.)

Printer status Print speed > EASYPLUGINTERPR > COM3 PORT Foil end warning Reprint function

Memory status Feed speed Interface Baud rate Foil warn stop Language

Font status Material type Spooler mode No. of data bits Print Interpret. Keyboard

Service status Material length Printer ID No. Parity Character sets Access authoriz.

Dottest endless Material width Spooler size Stop bits Character filter

Dottest punched Print direction Offline mode Data synch. Light sens. type

Reference label Punch offset Interface delay Frame error

Head-sensor dist 13/14

Bar code Multi. Sens. punch-LS

Tradit. Imaging 1/13 > COM1 PORT > CENTRONICS Foil mode

UPC plain-copy Baud rate PnP function Turn-on mode

EAN Readline No. of data bits Error reprint

EAN sep. lines Parity > OPTIONS EasyPlug errors

Rotated barcodes Stop bits Remote Display Single job mode

Dispenseposition Data synch. StandAlone Input Head resistance

X – Printadjust Frame error Temp. reduction

Y – Printadjust

Thin line emphas 13

Punch mode > COM2 PORT Voltage offset

Punch level 12 Baud rate Miss. label tol.

No. of data bits Gap detect mode

Parity Periph. device

Stop bits Singlestartquant

Data synch. Start mode

Serial port mode External signal

Frame error Print contrast

Ram disk size

Font downl. area

Free store size

Print info mode

FW 3.33