Service manual

ManualsBrandsAvery Dennison ManualsBusiness equipmentAP5.6

1. Only with PRINT PARAMETERS > Bar code Multi. = „ yes“ 2. Only with BLDC firmware version V4-T36 or higher 4. Only with at least one data block stored in the flash memory 5. Only with rewinder option

6. Only with cutter 7. Only with „AP 5.4 peripheral“ 10. Only with activated MONARCH LANGUAGE INTERPRETER™ 12. Only if PRINT PARAMETERS > Punch mode = Manual 13. Only in production mode

14. As in 13. or with a setting value > 0 18. Only with installed RFID option 20. Only if SYSTEM PARAMETERS > Periph. device = Dispenser 21. Only if SYSTEM PARAMETERS > Periph. device = Int Rewinder

22. Only with an activated RFID option 23. Only with I/O board 24. Not with I/O board 29. Availability depends on device configuration 30. Only with a CF card inserted 31. Only with WLAN CF card inserted

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters

AP 4.4 – AP 5.4 – AP 7.t

AP 5.4 Parameters

(SYSTEM PARAM. cont.)

I/O BOARD PARA 23 MLI PARAMETERS 10 DISPENSER PARA 20 REWINDER PARA 21 SPECIAL FUNCTION

Print info mode

Start delay 23 Version 10 Dispense Mode 20 Rewind direction 21 Command sequence 13

Reprint function

Start print mode 23 Darkness 10 Dispenseposition 20 Start mode 21 Default values 13

Language

Reprint Signal 23 Control Prefix 10 Display mode 20 Current mode 13+21 Delete job

Keyboard

Feed input 23 Format Prefix 10 Dispense counter 20 Min rew. current 13+21 Delete spooler

Access authoriz.

Pause input 23 Delimiter Char 10 Application mode 20 Max rew. current 13+21 Factory settings

Realtime Clock

Error output 23 Label Top 10 Start mode 20 Start rew. curr. 13+21 Parameter to CF

Error polarity 23 Left Position 10 Start source 20 Start cur. len. 13+21 Diagnosis to CF

Status output 23 Manual Calibrate 10 Calibration mode 20 Pullback current 13+21 Data blocks del. 4

Status polarity 23 Resolution 10 Current mode 13+20 Back diameter 13+21 System version

End print mode 23 Error Indication 10 Min rew. current 13+20 Break current 13+21 EasyPl. file log 30

Error Checking 10 Max rew. current 13+20 Break diameter 13+21 Log files delete 30

305 DPI Scaling 10 Start rew. curr. 13+20

Image Save Path 10 Start cur. len. 13+20

Command ^PR 10 Pullback current 13+20

Command ^MT 10 Back diameter 13+20

Label Invert 10 Break current 13+20

Command ^JM 10 Break diameter 13+20

FW 3.33