Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
109
2. Start the MS-DOS-window (using Windows).
3. Send any file to the printer (Condition: lpt1 = printer port; anyfile.txt = any
file):
copy anyfile.txt lpt1 (add /b for binary files)
The following shows up on the printer display:
xxxxxx is the size of the sent file in bytes. This value is being counted up dur-
ing the test. The test is complete if the file size does not vary any more. If the
bytes announced at the printer match the size visible in the MS-DOS window,
transfer was successful. Otherwise, transmission errors occurred.
Rewinder adjust
AP5.4 AP7.t
¯ AP 5.4/AP 7.t: Only with „Rewinder 2000“ installed.
Setting up the rewinder.
The rewinder setup compensates differeces in characteristic or assembly of
the light barrier.
P A setting description for the AP 5.4/AP7.t rewinder option is given in the
„Manual Rewinder 2000“, paragraph Adjusting the sensor .
Resting pos.xxx Setup of the resting position (xxx = actual sensor value).
End pos. xxx Setup of the End position (xxx = actual sensor value).
The setting follows in both cases this scheme:
1. Bring the dancer arm to its resting position.
2. Press the cut button
¯ Not the Online button (as with TTX x50)!
3. Bring the dancer arm to its end position.
4. Press the Online button.
Receive test
xxxxx Bytes