Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
106
Feed adjust
AP4.4 AP5.4 AP7.t
Corrects the material feed length. Such a correction can be necessary when
printing on very long labels, to compensate slippage-related feeding inaccu-
racy.
For application instructions, refer to the Service Manual, topic section
„Electronics Gen. 3“, chapter Adjusting the imprint position .
x.x % Setting range: -10,0 to +10,0; Step width: 0,1%; Default setting: 0%
Punch y calibr.
AP4.4 AP5.4 AP7.t
¯ Only in production mode
Compensating the variation of distance between punch sensor and thermal
bar of the printhead.
x.xmm Setting range: -3.0 to 3.0; Default setting: 0.0; Unit interval: 0.1
CompactFlashTest
AP5.4 AP7.t
Test Compact Flash Cards
Pressing the online button starts a test routine for the Compact Flash Card
memory. The following display shows up after successful testing:
If the Compact Flash Card is defective or not available, a corresponding error
report shows up.
For test purposes, the printer creates a file named TESTXXXX.TXT in the
root directory of the card. An already existing file with this name will be over-
written.
CompactFlashTest
Card Test O.K.