Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
105
Matend adjust
AP4.4 AP5.4 AP7.t
These printer types are equipped with a single light sensor which is designed
to detect both, punches and material end. The sensor must be able to detect
three different states:
y No material
y Only backing paper
y Backing paper + label face
The parameter
SERVICE FUNCTION > Matend adjust can set the limit between being
recognized as „only backing paper“ or as „material end“.
P For further information read the Service Manual, topic section
Service Electronics , „Setting the material end sensor“.
yy Level : xx Setting range: 0 to 255; Step width: 1; Default setting: 20
Matend tolerance
64-xx ALX92x DPM PEM PM3000 AP4.4 AP5.4 AP7.t
Material end tolerance
This is relevant for label stock with very long punches. To avoid those punch-
es being recognized as material end by mistake, can here the distance be
set, after which the gap over the light sensor is interpreted as material end.
¯ By choosing a very high material end tolerance, you loose the protection
of the print roller against being printed on!
xxx mm Setting range: 20-300 mm; Default setting: 35 mm
Feedadjust label
AP4.4 AP5.4 AP7.t
Prints a scale, which enables to calculate the feed adjust value (see next
parameter).
For application instructions, refer to the Service Manual, topic section
„Electronics Gen. 3“, chapter Adjusting the imprint position .