Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
104
EP Monitor Mode
AP5.4 AP7.t
¯ Parameter only appears in production mode.
¯ Activating this parameter may slow down the label rate. Therefore disable
the function after error analysis.
Interpreter data (Default setting) All received Easy-Plug data, apart from immediate com-
mands, are transmitted.
All data All received Easy-Plug data, including immediate commands, are trans-
mitted.
Head adjust
AP7.t
¯ Parameter only for authorised, trained service personnel!
Sensor adjust
AP4.4 AP5.4 AP7.t
¯ Parameter only appears in production mode.
P For detailed instructions sensor adjustment, please refer to the service
manual, topic section "Service Electronics", paragraph "Settings".
Sensor test
AP4.4 AP5.4 AP7.t
P
The description of the sensor test can be found in the printer service manual,
topic section „Service Electronics“, chapter Sensor test .
The values displayed are for checking the sensors (sensor check) and can
by adjusted by service personnel.
Cutter test
AP5.4 AP7.t
Makes it possible to test the cutter function without having to set the para-
meter
SYSTEM PARAMETER > Periph. device to „cutter“.
Press Cut Key Triggers a cut, if a cutter is installed. Without a cutter nothing will happen.