Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
100
Diagnosis to CF
AP5.4 AP7.t
Stores the diagnostic data on CF card. The default file name composes as
follows:
„Diagnose AP 5.4 203 Dpi A429403110613.log“
y AP 5.4 203 Dpi: printer type and printhead resolution
y A429403110613: serial number of the CPU board; equals the value
displayed under
SERVICE DATA > CPU board data > Serial number
P
For details read the service manual, topic section „Fault Location“, chapter
„Reading out diagnostic data“.
Data blocks del.
Delete data blocks
AP4.4 AP5.4 AP7.t
¯ Only appears, if at least one data block is in the flash memory.
Bxx (Default setting) After calling the parameter, data block number 01 is
displayed:
„B01“: block number 01
„diagnose inf“: name of the data block, is contained in the data block header.
If the flash memory contains more than one data block:
« Press the cut button several times, until the wanted data block appears.
Deleting a data block:
« Press the online button.
« Press the feed button to change to „yes“.
« Press the online button to delete the block.
All All data blocks contained in the flash memory are deleted.
Data blocks del.
B01 diagnose inf
Data blocks del.
Delete? --> no