Service manual

1. Only with PRINT PARAMETERS > Bar code Multi. = „ yes“ 2. Only with BLDC firmware version V4-T36 or higher 4. Only with at least one data block stored in the flash memory 5. Only with rewinder option
6. Only with cutter 7. Only with „AP 5.4 peripheral“ 10. Only with activated MONARCH LANGUAGE INTERPRETER™ 12. Only if PRINT PARAMETERS > Punch mode = Manual 13. Only in production mode
14. As in 13. or with a setting value > 0 18. Only with installed RFID option 20. Only if SYSTEM PARAMETERS > Periph. device = Dispenser 21. Only if SYSTEM PARAMETERS > Periph. device = Int Rewinder
22. Only with an activated RFID option 23. Only with I/O board 24. Not with I/O board 29. Availability depends on device configuration 30. Only with a CF card inserted 31. Only with WLAN CF card inserted
09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
10
AP 5.4 Parameters
AP 5.4 Parameter
PRINT INFO PRINT PARAMETERS INTERFACE PARA
(INTERFACE PARA cont.) (INTERFACE PARA cont.)
SYSTEM PARAMETER
Printer status Print speed > EASYPLUGINTERPR Parity
WLAN 128Bit key 2 31 Foil end warning
Memory status Feed speed Interface Stop bits
WLAN 128Bit key 3 31 Foil warn stop
Font status Material type Spooler mode Data synch.
WLAN 128Bit key 4 31 Print Interpret.
Flashdata status 4 Material length Printer ID No. Frame error WLAN com quality 31 Character sets
Service status Material width Spooler size
WLAN signal lev. 31 Character filter
Dottest endless Print direction Offline mode > CENTRONICS Light sens. type
Dottest punched Punch offset Interface delay PnP function > OPTIONS
Head-sensor dist 13/14
Reference label Bar code Multi. Remote Display Sens. punch-LS
RFID status 22 Tradit. Imaging 1/13 > COM1 PORT > NETWORK PARAM. RFID Option 18 Foil mode
UPC plain-copy Baud rate IP Addressassign StandAlone Input Turn-on mode
EAN Readline No. of data bits IP Address Error reprint
EAN sep. lines Parity Net mask EasyPlug errors
Cut mode 6 Stop bits Gateway address Single job mode
Cut position 6 Data synch. Port address Head resistance
Double cut 6 Frame error Ethernet speed Temp. reduction
Rewind direction 5 MAC address Thin line emphas 13
Rotated barcodes
> COM2 PORT 23 FTP server Voltage offset
X – Printadjust
Baud rate 23 FTP password 13 Miss. label tol.
Y – Printadjust
No. of data bits 23 WEB server Gap detect mode
Punch mode
Parity 23 DHCP host name Periph. device
Punch level 12 Stop bits 23 WLAN SSID 31 Singlestartquant
Data synch. 23 WLAN WEP 31 Start mode
Frame error 23 WLAN default key 31 External signal
Serial Port Mode 23 WLAN 64Bit key 1 31 Signal edge 24
WLAN 64Bit key 2 31 Print contrast
> COM3 PORT
WLAN 64Bit key 3 31 Ram disk size
Baud rate
WLAN 64Bit key 4 31 Font downl. area
No. of data bits
WLAN 128Bit key 1 31 Free store size
FW 3.33