User manual

04/10 Rev. 5.05-00 USER MANUAL Maintenance and Cleaning

AP 5.4 – AP 5.6

Changing the Print Roller

Tool

2,5 mm hex screwdriver (comes with the

printer).

Disassembly:

1. Switch off the printer and disconnect from

the power.

2. Remove material and foil from the printer.

3. Unfasten the screw [11B] in the middle of

the tear-off edge [11A]. Remove the tear-off

edge.

4. Release the set screw [11C].

5. Remove the print roller sideways [12].

Fitting:

1. Push the print roller through the external

bearing plate.

The printer roller axle is flattened on the

end.

2. Place the axle in the socket [12B] and gen-

tly rotate until the flat part [12C] of the axle

is under the set screw.

3. Press the print roller firmly into the socket.

¯ Ball bearing [13B] and bearing plate

[13A] must flush on the inner side!

4. Fasten the set screw.

WARNING!

Risk of burning injuries from a hot

printhead.

« Ensure that the printhead has coo-

led down before cleaning it.

[11] Print roller at an AP 5.6.

[12] Pull out the print roller (A).

[13] The ball bearing (B) and bearing plate (A) must flush at the inner

side.