Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
97
Intern. rewinder
(Internal rewinder)
AP5.4 AP5.6
¯ „AP 5.4/5.6 peripheral with internal rewinder“ only.
Applied PIC version on the internal rewinder motor output stage board.
> OPERATION DATA
Serv. operations
AP5.4 AP5.6
Shows the num+ber of service operations. The counter is increased by call-
ing the parameter
SERVICE FUNCTION > Service = yes. Maximum value: 4 billions.
Headnumber
AP5.4 AP5.6
Shows the number of printhead changes. The counter is increased by calling
the parameter
SERVICE FUNCTION > Cutter exchange = yes. Maximum value: 4 bil-
lions.
Roll number
AP5.4 AP5.6
Shows the number of exchanged print rollers. The counter is increased by
calling the parameter
SERVICE FUNCTION > Roller exchange > yes. Maximum value:
4 billions.
Cutter number
AP5.4 AP5.6
¯ Only with mounted and activated cutter.
Shows the number of exchanged cutters. The counter is increased by calling
the parameter
SERVICE FUNCTION > Cutter exchange =yes. Maximum value:
4 billions.