Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
96
SERVICE DATA
> MODULE FW VERS.
System version
AP5.4 AP5.6
Shows the firmware version number.
System revision
AP5.4 AP5.6
Shows a consecutive revision number.
¯ Only for factory-internal use.
System date
AP5.4 AP5.6
Shows the date, at which the firmware was generated.
Bootloader
AP5.4 AP5.6
Shows the bootloader version number.
uMon
AP5.4 AP5.6
Shows the bootloader version number.
Peripheraldriver
AP5.4 AP5.6
¯ Only with mounted (optional) peripheral output stage board.
Applied PIC version on the output stage board driving the peripheral motor.