Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
91
Matend tolerance
AP5.4 AP5.6
Material end tolerance
This is relevant for label stock with very long punches. To avoid those punch-
es being recognized as material end by mistake, can here the distance be
set, after which the gap over the light sensor is interpreted as material end.
¯ By choosing a very high material end tolerance, you loose the protection
of the print roller against being printed on!
xxx mm Setting range: 20-300 mm; Default setting: 35 mm
Feedadjust label
AP5.4 AP5.6
Prints a scale, which enables to calculate the feed adjust value (see next
parameter).
For application instructions, refer to the Service Manual, topic section
„Electronics Gen. 3“, chapter Adjusting the imprint position .
Feed adjust
AP5.4 AP5.6
Corrects the material feed length. Such a correction can be necessary when
printing on very long labels, to compensate slippage-related feeding inaccu-
racy.
For application instructions, refer to the Service Manual, topic section
„Electronics Gen. 3“, chapter Adjusting the imprint position .
x.x % Setting range: -10,0 to +10,0; Step width: 0,1%; Default setting: 0%
Punch y calibr.
AP5.4 AP5.6
¯ Only in production mode
Compensating the variation of distance between punch sensor and thermal
bar of the printhead.
x.xmm Setting range: -3.0 to 3.0; Default setting: 0.0; Unit interval: 0.1