Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
90
EP Monitor Mode
AP5.4 AP5.6
¯ Parameter only appears in production mode.
¯ Activating this parameter may slow down the label rate. Therefore disable
the function after error analysis.
Interpreter data (Default setting) All received Easy-Plug data, apart from immediate com-
mands, are transmitted.
All data All received Easy-Plug data, including immediate commands, are trans-
mitted.
Sensor adjust
AP5.4 AP5.6
¯ Parameter only appears in production mode.
P For detailed instructions sensor adjustment, please refer to the service
manual, topic section "Service Electronics", paragraph "Settings".
Sensor test
AP5.4 AP5.6
P
The description of the sensor test can be found in the printer service manual,
topic section „Service Electronics“, chapter Sensor test .
The values displayed are for checking the sensors (sensor check) and can
by adjusted by service personnel.
Cutter test
AP5.4 AP5.6
Makes it possible to test the cutter function without having to set the para-
meter
SYSTEM PARAMETER > Periph. device to „cutter“.
Press Cut Key Triggers a cut, if a cutter is installed. Without a cutter nothing will happen.