Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
89
Cutter exchange
AP5.4 AP5.6
¯ Parameter only appears in production mode and only with a cutter
mounted and activated.
Increases the counter „Cutter number“ on the info printout „Service Status“
by one.
P See parameter Service Status on page 24.
yes Increases the counter "Cutter number" by one
no Doesn´t increase the counter
Serv. data reset
AP5.4 AP5.6
¯ Parameter only appears in production mode.
Sets all counters on the info printout „Service Status“ to zero.
P See parameter Service Status on page 24.
EasyPlug monitor
AP5.4 AP5.6
¯ Parameter only appears in production mode.
The parameter activates the logging of received Easy Plug data. Data is
transmitted to COM1 or COM2.
¯ Activating this parameter may slow down the label rate. Therefore disable
the function after error analysis.
¯ To keep the influence of the monitoring function on the data rate as low
as possible, the baud rate should be set to 115,000!
Disabled (Default setting) The monitor function is disabled.
Serial Com1 The Easy-Plug monitor data is transmitted to Com1.
Serial Com2 The Easy-Plug monitor data is transmitted to Com2.