Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
85
Delete spooler
AP5.4 AP5.6
Press the Online-key to delete all print jobs contained in the spooler.
Factory settings
AP5.4 AP5.6
All parameters are preset ex works to values specific to each device type.
These factory settings can be restored at any time.
All parameters are then overwritten by the factory settings.
The currently valid settings can be checked using
PRINT INFO > printer status.
¯ CAUTION! - All data present in the spooler, including data belonging to an
interrupted print job, is deleted!
Store Parameters
AP5.4 AP5.6
Parameter settings are saved in a text file on SD-card (directory FORMATS\).
Considered are also parameters which belong to options, which are not acti-
vated.
Without adj. par (Default) Parameters, which contain device specific settings, are not saved.
(Default file name: SETUP.FOR).
Application example: Transfer of printer settings to another printer (device
specific settings as printhead resistance or sensor settings should not be
overwritten).
With adjust para Parameters, which contain device specific settings, are also saved. The rel-
evant parameter names are marked with a * in the text file.
(Default file name: SETUPALL.FOR).
Application example: Service
P For more information about saving and reading parameter settings read topic
section „Advanced Applications“, chapter „Saving and Transferring
parameter settings“.
Delete Spooler
Clearing . . .