Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
84
SPECIAL FUNCTION
Printer type
AP5.4 AP5.6
¯ Only in production mode.
Selection of the machine type. Must be set after the CPU board was replaced
or after new firmware was loaded.
¯ CAUTION! - Selecting an inappropriate machine type can lead to
malfunctions or damage!
AP5 AP5.6
AP7 AP7.t
Default Values
AP5.4 AP5.6
¯ Parameter appears only in production mode.
User defined The presently selected settings of all parameters will be taken as default val-
ues. That is you will get those settings back even after a firmware update. All
you have to do is to call the parameter "Factory settings".
Standard Calling the parameter "Factory settings" will set all parameters to the factory
preset values.
Command sequence
AP5.4 AP5.6
¯ Parameter appears only in production mode.
~ „~“ is used as start sign for Easy-Plug command sequences.
# (Default setting) „#“ is used as start sign for Easy-Plug command sequences.
Delete job
AP5.4 AP5.6
Press the Online-key to cancel the active print job.
Delete Job
Clearing . . .