Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
83
Label Invert
AP5.4 AP5.6
Rotates the printout by 180°. Equals the parameter PRINT PARAMETERS >
Print direction
, which will be ignored, when MLI printjobs are printed.
[17] Orientation of the printout: Setting „Disable“ (A) or „Enable“ (B).
Disable The label is printed with „normal“ orientation [20A].
Enable The label printout is rotated by 180° [20B].
Command ^JM
AP5.4 AP5.6
¯ Interpreter version: 1.32 or higher
The ^JM command changes the printer resolution:
y ^JMA sets the resolution to the default value = printhead resolution.
y ^JMB sets the resolution to 200dpi, if the actual resolution is 300 dpi. If the
actual resolution is 200dpi, this command is ignored.
Disable The resolution setting sent in the MLI printjob is ignored.
Enable The resolution setting is not ignored.
Command ^MD/~SD
AP5.4 AP5.6
The MLI commands ^MD and ~SD (set printhead darkness value) are proc-
essed optionally.
Enable ^MD- and ~SD are processed.
Disable ^MD- and ~SD are ignored.
AB
Printer
Printout