Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
82
Error Indication
AP5.4 AP5.6
Selects the way, in which the printer responds in the event of error occuring
during printing.
Error Checking
AP5.4 AP5.6
Enables or disables error checking, when the printer is handling print fields.
YES Error checking is enabled. (Default)
NO Error checking is disabled.
Image Save Path
AP5.4 AP5.6
Selects the memory to be used by the ^IS and ^IL commands.
¯ Interpreter version: 1.10 or higher.
CF Card Optional CompactFlash card
Internal RAM The printer´s internal RAM. (Default)
Command ^PR
AP5.4 AP5.6
Disable The print rate sent in the MLI printjob is ignored.
Enable The print rate is not ignored.
Command ^MT
AP5.4 AP5.6
Disable The material type sent in the MLI printjob is ignored (thermo-transfer or ther-
mo-direct).
Enable The material type is not ignored.
Error
Level
Setting
LOW HIGH OFF
0 Ignore Ignore Ignore
1 Ignore Flash on the display Ignore
2 Prompt user for action Prompt user for action Ignore
[8] Error handling settings.
Low
High
Off