Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
80
MLI PARAMETERS
Avery Dennison's MONARCH LANGUAGE INTERPRETER™ (MLI™) helps
you use an Avery Dennison 4.4, 5.4, 64xx, ALX92X, DPM/PEM, or AP7.t
printer which was set up for use with ZIH Corp.’s ZPL II®
1)
. If you have any
questions about using an Avery Dennison printer with these data streams,
please contact Service.
This section lists the ZPL II® commands that the Avery Dennison printer's
MONARCH LANGUAGE INTERPRETER™ can interpret with any special
notes, if applicable.
¯ This menu appears only with SYSTEM PARAMETERS > Print Interpret. set to „MLI“
or „EasyPlug / MLI“.
¯ MLI is not supported in Standalone Mode.
¯ Recommended settings:
SYSTEM PARMETER > RAM disk size at least 2048 Kbytes
SYSTEM PARAMETER > Free store size at least 2048 Kbytes
Darkness
AP5.4 AP5.6
Print contrast for MLI printjobs. This setting is modified by printjobs which
contain print contrast information. The print contrast set by
SYSTEM PARAMETERS > Print contrast is not influenced by this setting.
xx Setting range: 0-30; Step width: 1; Default setting: the Easy-Plug setting is
overtaken.
Control Prefix
AP5.4 AP5.6
Indicates the start of a MLI control instruction.
xxH Default: xx = 7E (0x7E = „Tilde“)
Format Prefix
AP5.4 AP5.6
Indicates the start of a MLI format instruction.
xxH Default: xx = 5E (0x5E = „Caret“)
1) ZPL II is a registered trademark of ZIH Corp. ZIH Corp. and Avery Dennison (including Paxar
Corporation and its subsidiaries) are not related in any way, and ZIH Corp. has not licensed or
otherwise sponsored MONARCH® printers or Avery Dennison's MONARCH LANGUAGE
INTERPRETER™. MONARCH®, MONARCH LANGUAGE INTERPRETER, MLI are trademarks
of Paxar Americas, Inc. Avery Dennison is a registered trademark of Avery Dennison
Corporation.