Service manual

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
77
The diameter up to which the Pullback current is throttled down to zero
(parameter Back diameter), and the diameter, from which on the brake cur-
rent starts (parameter Brake diameter).
The parameter Pullback current sets the support current for the rewinder at
the minimum diameter of 25mm. When the diameter of the rewound label
web reaches the set value (Back diameter), the support current will be throt-
tled down to a mimimum.
Back diameter
AP5.4 AP5.6
Pullback current diameter
P See parameter Pullback current  on page 118.
¯ If the label web is loose, while it is fed back under the printhead, decrease
this value in small steps. If the material is tightened too much, increase the
value in small steps.
XX mm Setting range: 0-120 mm; Default setting: 50 mm
Brake current
AP5.4 AP5.6
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Sets the brake current
P See parameter Pullback current  on page 118.
XXX Setting range: 0-100; Default setting: 0
Brake diameter
AP5.4 AP5.6
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Sets the break diameter.
P See parameter Pullback current  on page 118.
XXX Setting range: 0-120; Default setting: 120