Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
72
Display mode
AP5.4 AP5.6
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Makes the already printed labels appear in the display instead of the not yet
printed ones.
Job rest quant. Display of the not yet printed labels of a print job.
¯ The counter keeps it´s value even after switching the printer off.
Dispense counter Counting of start pulses. Activate the counter by selecting "Dispense coun-
ter". The counted number appears on the display after the parameter
Dispense counter (see below) has been selected.
Dispense counter
AP5.4 AP5.6
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
¯ The displayed value can be varied by pressing the Cut or Feed button.
There are two ways of setting back the counter:
y Set the parameter Display mode (see above) to "Job rest quant." , then back
to "Dispense counter" and confirm by pressing the Online button.
y Reduce the displayed number by pressing the Cut button.
Application mode
AP5.4 AP5.6
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Save Mode A start signal is required to draw the next label back under the print head. This
setting bears advantages for label material with a strong adhesive, which
would not stay attached to the applicator when the backing paper is fed back-
wards.
Immediate Mode After the just printed label has reached the dispense position, the following
label is drawn back under the print head. The dispensed label stays attached
to the applicator (default setting).
Synchronous mode Not yet implemented (Fw. 3.33).
Dispense counter
xxxxxx
xxxxxx = Number of dispensed labels.