Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
71
Batch Mode y The printer can print the whole label surface.
y Dispensing of the label takes place during printing. Printing of the next label
is interrupted until the label is completely dispensed.
y The output volume is at its maximum level.
¯ The Batch mode is optimised for printing and dispensing at high speeds.
Due to this, it is not possible to use all features awaliable in modes
Normal 1:1 or Real 1:1. Also consider, that printing data must be available on
time and in sufficient quantity.
¯ The following Job/Parameter-combinations must not be used:
y Jobs with counter fields
y Jobs with variable fields
y
SYSTEM PARAMETER > Dispensing mode must be set to "fast".
y The USI reprint function is not supported.
DP INTERFACE > Reprint signal must be
set to "deactivated".
y Foil save
P A graphic can be found under PRINT PARAMETERS > Cut mode > Batch mode.
Real 1:1 Mode (Default setting)
y The printer can print the whole label surface.
y After dispensing a label, the beginning of the next label is drawn back under
the print head.
y The output volume is lower than in Batch Mode or Normal 1:1 Mode.
P A graphic can be found under PRINT PARAMETERS > Cut mode > Real 1:1 mode.
Dispenseposition
AP5.4 AP5.6
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Dispense position
Adjusts the dispense position in or against the feed direction. Depending on
the set dispense position, the dispensed label sticks to the backing paper with
a more or less wide strip (Fig. 11). The required width of this strip depends
on the further processing.
[16] Dispense position (= stopp position) of the dispensed label.
x.x mm Setting range: -30.0 to +20.0 mm; Unit interval: 0.1 mm; Default
setting: -6.0 mm
Dispensed label
Dispense position
Dispensing edge
Backing paper
Z0040E.cdr