Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
70
DISPENSER PARA
¯ This menu appears only in AP 5.4/5.6, and only, if SYSTEM PARAMETER >
Periph. device is set to „Dispenser“.
Dispense Mode
AP5.4 AP5.6
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Governs the run of the print-dispense procedure.
¯ The ribbon autoeconomy function can only be used in "Real 1:1 Mode"!
Normal 1:1 Mode y The printer cannot print on the whole label surface. A stripe at the label
beginning stays unprinted.
y The label is being dispensed while printing.
y The output volume is at its maximum level.
¯ The width of the unprintable stripe is calculated as follows:
Distance print line to dispensing edge (25mm) + Dispense position
P Also refer to parameter PRINT PARAMETERS > Dispense position.
P A graphic can be found under PRINT PARAMETERS > Cut mode > Normal 1:1 mode.
[15] The size of the not imprintable area in Normal 1:1 depends of the setting of parameter
"SYSTEM PARAMETERS > Dispense Position".
a
b
c
Label
Backing paper
Printing
Printhead
Dispensing
Edge
Feed
Direction
Non-printable area with
Dispense
Dispense
a) Dispense position = 0
b) position < 0
c) position > 0
Z0137E.eps