Service manual

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
7
Operating the parameter menu
The illustrations on the following pages clarifie the operating principle of the
parameter menu. The return path shown on the left of the screen, called up
using the Prog. button, also applies for parameters in the middle of the
screen.
Setting values The setting of a parameter always follows this scheme:
1. Select the parameter.
2. Press the Online button.
3. Set the parameter to the intended value by pressing the Cut or Feed button.
4. Confirm by pressing the Online button.
Example
Setting the parameter PRINT PARAMETERS > Material type to punched material.
1. Press prog button.
2. Press prog button.
3. Press cut button.
4. Press online button.
5. Press cut button repeatedly, until the following is displayed:
6. Press feed button.
7. Press online button.
8. Press prog button 2x.
OFFLINE 0 JOBS Initial state: off-line mode
PRINT INFO
PRINT PARAMETERS
PRINT PARAMETERS
Print speed
First parameter in the PRINT PARAMETERS menu.
Material type
Endless
Material type
Punched
Setting the parameter to the intended value by
pressing the Cut or Feed button.
PRINT PARAMETERS
Material type
Confirm with Online button.
OFFLINE 0 JOBS "Way back" by pressing the Prog button.