Service manual

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
68
y Printhead pressure lever was opened during the printing of a label.
y Start print error
y Other errors, which keep the printer from printing
¯ During the initialization (powering up) of the printer, the ERROR-signal is
instable!
Printererr + Offl In addition to the above mentioned cases avtivate the following events the
ERROR-signal:
y The printer is in offline mode
y The printhead pressure lever is open
y „I/O board pause“ mode
y Stopped mode (the printing was stopped)
Error Polarity
AP5.4 AP5.6
¯ Only with an I/O board mounted.
Switches the polarity of the ERROR signal.
Level high activ The output is high when it is active, otherwise low.
Level low active The output is low when it is active, otherwise high. (Default)
Status output
AP5.4 AP5.6
¯ Only with an I/O board mounted.
This parameter defines different events, which activate the output signal
MACHINE STATUS.
Low ribbon warn The signal is activated, if the ribbon roll diameter is less than the limit.
P See parameter Foil end warning  on page 68.
Print job ready The signal is activated, if the printer has finished image processing and is
ready to start printing.
The signal is not activated, if:
y the print job is done,
y the print job was stopped,
y the printer was switched to offline mode,
y the printer is in pause mode.
Status polarity
AP5.4 AP5.6
¯ Only with an I/O board mounted.
Switches the polarity of the MACHINE STATUS signal.
Level high active The output is high when it is active, otherwise low.
Level low active The output is low when it is active, otherwise high. (Default)