Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
64
¯ CAUTION! - The key code "production" allows the access to parameters,
which are used during production to adjust the printer. Input errors to those
parameters can make the printer inoperable or can damage it. For this
reason, the production code may only be applied by trained service
technicians!
¯ Especially service technicians may use the direct access into production
mode, even if the parameter Access authoriz. is set to Deactivated, what
means that no password will be queried at all. To do so, proceed as follows:
1. Switch printer off.
2. Switch printer on, simultaneously press the Feed+Prog-key until the printer
type is displayed.
After the printer was powered up, the key code will be queried:
3. Enter the production code.
Possible Settings
Deactivated Password interrogation switched off (default)
Power-up code Activates the password interrogation directly after switching the printer on.
After the input of a valid key code, the printer switches into offline mode.
Depending on the entered key code, the printer starts in user, supervisor or
production mode.
User Activates the password interrogation when accessing the parameter menu.
y The printer is in the offline mode after switch-on
y Change to the online mode is possible without restriction
y To reach the parameters-menu, enter a valid key code
y Valid key codes: all
Supervisor As setting „User“, with different valid key codes:
y Valid key codes: Supervisor, Production
User auto start Printer starts without password interrogation. Only the menus
PRINT INFO and
SERVICE DATA are accessible.
Mode Key code Impact
User 2x Cut Feed, Online Access only to the submenus
PRINT INFO and SERVICE DATA
Supervisor 2x Online, Feed, Cut, 2x Online Access to all parameters ex-
cept production parameters
Production Cut, Online, Feed, Cut, 3x Online Access to all parameters
[5] Permissible key codes.