Service manual

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
62
Free store size
AP5.4 AP5.6
By setting this parameter, a part of the memory is reserved, which the printer
firmware can use if necessary (dynamic memory allocation). If this memory
area is dimensioned too small, the printer firmware can not work and the error
message „8856 Free store size“ shows up.
¯ The more memory is allocated using this parameter, the less memory is
available for print jobs.
xxx KBytes Setting range: 2048KBytes to the maximum size, which depends on the
memory configuration and allocation of the printer; Unit interval: 128KBytes;
Default setting: 2048KBytes.
« A good advice is to increase the set value step by step, starting with the mi-
nimum of 2048 KBytes, until the status message 8856 ("Free store size",
what means the memory area is low) does no longer appear during data con-
version.
P Use with the Easy Plug command #YG, see manual Easy Plug .
P See parameter Memory status  on page 18.
Print info mode
AP5.4 AP5.6
Structure option for info printouts.
Par. values right Setting for 100mm material width. The parameter values are printed on the
right side of the parameter names:
Parameter name: Value
Par. values left Setting for 100mm material width. The parameter values are printed on the
left side of the parameter names:
Value: Parameter name
Compact right Setting for 50mm material width. The parameter values are printed on the
right side of the parameter names:
Parameter name: Value
Compact left Setting for 50 mm material width. The parameter values are printed on the left
side of the parameter names:
Value: Parameter name
Reprint function
AP5.4 AP5.6
Disabled (Default setting) Reprinting is not possible.
Enabled The last printed label can be reprinted by pressing the feed button in online
mode, if the printer is not printing at that moment.