Service manual

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
60
Start print mode
AP5.4 AP5.6
¯ Only appears, if no I/O board is installed. Otherwise, the parameter
appears in the I/O BOARD menu.
See parameter Start print mode
 on page 102.
Print contrast
AP5.4 AP5.6
xxx% Setting range: 1 to 120%; Unit interval: 1; Default setting: 60
Ram disk size
AP5.4 AP5.6
A part of the printer memory can be identified as a RAM disk. The RAM disk
can be used in the same way as the Compact Flash Card, e.g. for storage of
logos or fonts.
With the parameter Ram disk size, the customer can set the size of the RAM
disk to his needs. Be aware, that RAM disk memory is not available for print
picture buildup. Use of much RAM disk memory reduces the picture buildup
rate of the printer.
¯ Switching the printer off extinguishes the memory content! Fonts, logos
etc., which were loaded on the RAM disk, must be loaded again after
switching the printer off.
xxxx KBytes Setting range: 2048 KBytes to the maximum size, which depends on the
memory configuration and allocation of the printer; Unit interval: 128KBytes;
Default setting: 512 KBytes
CAUTION!
The parameter
Print contrast affects directly the life durance of the printhead.
It counts: „The higher the setting of
Print contrast is, the lower is the life dur-
ance of the printhead“. This counts even more for settings above 100%.
Therefore mind:
« Always choose the lowest possible setting necessary to produce an accep-
table print result.