Service manual

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
58
Thin lines in the printout, which run crossways to the printing direction, are
printed approx. 1.5 times wider. This may have the effect, that small white
patches are closed with color (e.g. in the „e“ with very small fonts).
Off Print emphasis for thin lines is switched off.
Voltage offset
AP5.4 AP5.6
The voltage offset increases the head voltage and therefore the head tem-
perature which e.g. was set by Easy Plug command (HV).
xx% Setting range: 0 to 20%; Unit interval: 1%
Default setting: 0%
Miss. label tol.
AP5.4 AP5.6
Missing label tolerance
The maximum search path for gaps which cannot be found can be varied. In
cases of difficult gap detection (i. e. minimum variation in the light transpar-
ency, gap to label), shortening the search path is to be recommended. Label
loss resulting from gaps not being detected can be reduced in this way. Print-
ing does not take place during the search process.
xx Setting range: 0 to 50; Unit interval: 1
y Example 0 (Zero label length): A gap must be found after a printed label
otherwise an error message is given. This setting is for detecting every
missing label.
y Example 5 (Five label lengths): A gap must be found after a maximum of 5
label lengths otherwise an error message is given.
Gap detect mode
AP5.4 AP5.6
After one of the following events, the printer must always search for the
punch, that is initialize the label material:
y After switching the printer on
y After changing the label material
Manual The operator has to initialize the material always manually by pressing the
feed key several times.
Autom. Forward (Default for printers) The material initialization is always done automatically,
if necessary. There is no backward movement of the material during the ini-
tialization.