Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
57
Setting:
1. From the print head, read off the resistance value to be set and make a note
of it (1000 to 1500).
2. In off-line mode press the Prog. button, display: PRINT INFO.
3. Press the Cut button until SYSTEM PARAMETER is displayed.
4. Press the Online button, display:
5. Press the Cut button until the following is displayed:
6. Press the Online button, set value is displayed.
7. Set the previously noted resistance value of the print head using the Feed
and Cut buttons.
8. Press the Online button to confirm the set value.
9. Press the Prog. button to return to the display OFFLINE 0 JOBS.
Temp. reduction
AP5.4 AP5.6
Reduction in the print head temperature
The parameter
SYSTEM PARAMETER > Temperature reduct. allows the power supply
to be reduced in the event of an increase in the print head temperature, there-
by ensuring an evenly good print image.
xxx% Setting range: 0 to 100%; Unit interval: 5%
The following setting alternatives are available:
y 0%: No temperature reduction.
y xx%: Up to xx% temperature reduction with a hot print head.
y Default setting: 20%.
P For further information refer to the user manual, topic section „Advanced
Application“, chapter „Printing with Termperature Compensation“
Thin line emphas
AP5.4 AP5.6
¯ Only in production mode
Thin line emphasis. Print emphasis for thin lines in order to get a better print
result.
On (Default) Print emphasis for thin lines is switched on.
SYSTEM PARAMETER
Foil end warning
SYSTEM PARAMETER
Head resistance