Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
55
Sens. punch-LS
AP5.4 AP5.6
Sensitivity punch light sensor
Sets the sensitivity of the material photoelectric switch.
xxx% Setting range: 10 to 100%; Unit interval: 10%
Default setting: 50%
Maximum sensitivity: 100%. for narrow gaps (perforations).
Minimum sensitivity: 1%. for clearly detectable gaps.
¯ Too high a level of sensitivity can lead to gaps being detected which do
not even exist (on proofs, material thickness fluctuations, perforations etc.).
Foil mode
AP5.4 AP5.6
Thermo transfer Thermo transfer printing (Ribbon sensor activated)
Thermal printing Thermo direct printing (Ribbon sensor deactivated)
Turn-on mode
AP5.4 AP5.6
Operating mode of the printer after it has been switched on.
Online Printer starts in on-line mode.
Offline Printer starts in off-line mode.
Standalone Printer starts in standalone mode.
Error reprint
AP5.4 AP5.6
If an error occurs while a label is printed, the last printed label will normally
be reprinted. In case of label layouts containing variable data like e.g. count
fields, switching off the reprint function possibly makes sense.
Enabled Reprint in error cases (default setting)
Disabled No reprint in error cases.