Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
51
> DRIVEASSIGNMENT
P For detailed information read the Easy-Plug manual, topic section General
Notes, Definitions and Command Overview , chapter „Drive names“.
Drive C
AP5.4 AP5.6
Assigns drive letter C: to the card slot or to the USB port.
None C: is not assigned
(Default setting) C: is assigned to the SD card slot.
USB-stick C: is assigned to the USB host port.
Drive D
AP5.4 AP5.6
Assigns drive letter C: to the card slot or to the USB port.
None D: is not assigned
SD card D: is assigned to the USB host connector