Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
45
Gateway address
AP5.4 AP5.6
xxx.xxx.xxx.xxx Setting range per xxx value: 0 to 255
000.000.000.000 = no gateway is used
Port address
AP5.4 AP5.6
Setting range: 1024 to 65535. Default: 9100.
Ethernet speed
AP5.4 AP5.6
Auto negotioation The communication speed is selected automatically.
10M half duplex The communication speed is set to 10 MBit/s half duplex.
10M full duplex The communication speed is set to 10 MBit/s full duplex.
100M half duplex The communication speed is set to 100 MBit/s half duplex.
100M full duplex The communication speed is set to 100 MBit/s full duplex.
MAC address
AP5.4 AP5.6
Displays the MAC address of the CPU board. This address can not be
changed in the parameter menu.
SNMP agent
AP5.4 AP5.6
¯ Function is not released yet.
SNMP password
AP5.4 AP5.6
¯ Only in production mode.
¯ Function is not released yet.