Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
Cuts on knife ........................................... 98
Tot. mat. length ....................................... 98
Tot. foil length.......................................... 98
Total cuts................................................. 98
Head strobes........................................... 99
Head temperature ................................... 99
Foil diameter ........................................... 99
Dispensing cycl. ...................................... 99
Operation time......................................... 99
> POWERSUPPLYDATA
Type ...................................................... 100
PS temperature..................................... 100
> CPU BOARD DATA
CPU identifier........................................ 100
PCB revision ......................................... 100
FPGA version........................................ 100
MAC address ........................................ 100
Serial number ........................................ 100
Production date...................................... 101
PCB part number................................... 101
Board part numb.................................... 101
Manufacturer.......................................... 101
Work place............................................. 101
Company name ..................................... 101
> DISPLAY DATA
Display version ...................................... 102
Display SerialNr..................................... 102
> MEMORY DATA
Ram memory size.................................. 102
Flash mem size...................................... 102
SD card.................................................. 103
Space for Jobs....................................... 103
Max. Labellength ................................... 103
Default values........................................ 103