Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
38
INTERFACE PARA
Interface parameter
> EASYPLUGINTERPR
Interface
AP5.4 AP5.6
Interface type
This parameter sets the interface, by which the printer will receive data.
Serial Com1 Serial interface Com1.
P Selection of the type of serial interface is done with parameter INTERF. PARAM >
EASYPLUGINTERPR > Serial Port Mode
.
Only for Ethernet interface (10/100 Base T):
TCP/IP Socket Print data can be sent to the printer via a TCP/IP socket
LPD Server Print data can be sent to the printer via the LPR/LPD-protocol
USB USB 1.1 interface
Serial Com3 Serial interface Com3.
¯ Only with optional I/O board mounted.
Automatic All interfaces are enabled to receive data, but not simultaneously.
¯ Don´t send data to more than one interface at a time.
¯ Except are interfaces, which are being used by an option (e.g. OLV).
Spooler mode
AP5.4 AP5.6
The operating mode of the spooler determines whether print series are proc-
essed individually, or whether the spooler can receive print data when print-
ing several series.
Single print job Single print series mode (the interface can only receive data after printing the
required number of labels of a single series)
Mult. print jobs Multiple print series mode (the interface can receive data while the series is
being printed)