Service manual

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
36
Rewind direction
AP5.4 AP5.6
¯ Only with mounted and activated rewinder (SYSTEM PARAMETERS >
Periph. device
= „Rewinder“).
Determines the sense of rotation of the optional Rewinder.
Printing outside Rewind direction: The printed label is facing outside.
Printing inside Rewind direction: The printed label is facing inside.
X - Printadjust
AP5.4 AP5.6
The zero point of the mask is moved in relation to the edge of the label on the
X- axis, i. e. lengthways to the material.
¯ If the setting is changed, while the print job is stopped, the printer
recalculates the format using the changed values.
¯ Caution with graphics, which are generated via one of the Easy Plug
commands #YI, #YIR or #YIB! If the graphics is shifted beyond the label
border as a consequence of changing the parameter "X-Printadjust", the part
of the graphics which "juts out" will get lost.
x.xmm Setting range: -5.0 to +5.0 mm; Unit interval: 0.1mm
Default setting: 0.0 mm
y Maximum offset away from the edge of the label: +5.0 mm
y No offset: 0.0mm
y Maximum offset towards the edge of the label: -5.0 mm
Y – Printadjust
AP5.4 AP5.6
The zero point of the mask is moved in relation to the gap position on the
Y-axis, i. e. in the feed direction.
¯ If the setting is changed, while the print job is stopped, the printer
recalculates the format using the changed values.
¯ Caution with graphics, which are generated via one of the Easy Plug
commands #YI, #YIR or #YIB! If the graphics is shifted beyond the label
border as a consequence of changing the parameter "Y-Printadjust", the part
of the graphics which "juts out" will get lost.
x.xmm Setting range: -5.0 to +5.0 mm; Unit interval: 0.1mm
Default setting: 0.0 mm
y Maximum offset in feed direction: +5.0 mm
y No offset: 0.0mm
y Minimum offset against feed direction: -5.0 mm