Service manual

Table Of Contents

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters

AP 5.4 Gen II – AP 5.6

Batch mode The whole surface of the label is printable. Cutting takes place during print-

ing. This can result in brief interruptions within the print zone of the following

label. The output volume is at its maximum level.

Requirements for the batch mode are:

y Ribbon economy is not active (parameter

SYSTEM PARAMETERS >

Ribbon autoecon.

= "Deactivated")

y Material length >18 mm (>14 mm on the TTX 350)

y Number of cuts for a print job - at least 2 or more

[13] Printing process in Batch mode (schematic).

Normal 1:1 mode In N1:1 mode, cutting takes place during printing. The zero-line of the printing

is shifted 18 mm in y-direction. This offset equals the distance cutter-print-

head. Caused by this shifting, the first 18 mm of the label are not printable.

These measurement corresponds to the distance between print head and

cutter. The output volume is at its maximum level.

(The offset of the zero-line is caused historically and serves the compatibility

of older printer models).

[14] Printing process in Normal 1:1 mode (schematic).

Avery

Printhead

Cutter

1. Printing

2. Stop printing +

cut

3. Continue

printing

Avery

Printhead

Cutter

1. Printing

2. Printing

End

3. Feeding

4. Cutting