Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
33
Cut mode
AP5.4 AP5.6
¯ Only with mounted and activated cutter (SYSTEM PARAMETERS >
Periph. device
= „Cutter“).
This is where the procedure for the label output and cut is defined.
Real 1:1 mode The whole surface of the label is printable. The label is pushed forward to the
cutter for cutting. After the cut, the beginning of the next label is drawn back
under the print head. This reduces the output volume (in relation to a certain
time).
[12] Printing process (schematic) in „Real 1:1 Mode“.
Avery
Avery
Avery
Avery
Printhead
Cutter
1. Printing
2. Printing finished
3. Feeding
4. Cut and
feed back