Service manual

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
32
EAN sep. lines
AP5.4 AP5.6
EAN separation lines. Parameter for controlling of EAN or UPC barcodes if
they are printed without readline.
With readl. only (Default) The seperation bars at the beginning, end and in the middle of the
barcode are only long, if the barcode is printed with a readline.
Always long The seperation bars at the beginning, end and in the middle of the barcode
are always long, regardless if the barcode is printed with or without readline.
The position of the barcode is the same as with the readline option switched
on.
Rotated Barcodes
AP5.4 AP5.6
Improves the readability of rotated (90° and 270°) bar codes.
Normal „Normal“ printing without a special processing of rotated bar codes.
Optimized (Default setting) The line and gap widths of rotated bar codes are modified in
order to improve their readability.
Dispenseposition
AP5.4 AP5.6
Dispense position
Adjusts the dispense position in or against the feed direction. Depending on
the set dispense position, the dispensed label sticks to the backing paper with
a more or less wide strip [13]. The required width of this strip depends on the
further processing.
[11] Dispense position (= stopp position) of the dispensed label.
x.x mm Setting range: -30.0 to +20.0 mm; Unit interval: 0,1 mm; Default
setting: 0 mm
Dispensed label
Dispense position
Dispensing edge
Backing paper
Z0040E.cdr