Service manual

03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
31
Tradit. Imaging
AP5.4 AP5.6
¯ In production mode only.
Up to firmware version x.31, the barcode height was calculated with the
formula:
with x =
PRINT PARAMETERS > Barcode Multi.
By doing so, the printed barcode height in millimeters was by 1 higher than
the value defined in the layout (1 --> 2 mm, 2 --> 3 mm, etc.)
1)
.
From firmware version x.31 on, the printed barcode is exactly as high in mil-
limeters, as the value in the layout is (1 --> 1mm, 2 --> 2 mm, etc.)
1)
.
No New height calculation (1 --> 1mm, 2 --> 2 mm, etc.) is applied (default set-
ting).
The plain copy line is printed with OCR-B font.
Yes Setting for customers with print layouts based on the old height calculation
scheme.
The plain copy line of the barcodes EAN8, EAN13, UPC-A and UPC-E is prin-
ted with the same fonts, which older printer types like TTK or TTX x50 have
used.
UPC plain-copy
AP5.4 AP5.6
The position of the first and last digit in the plain-copy line - underneath the
bar code - can be adjusted as required.
Raised First and last digit of the UPCA or first digit with the UPCE are raised (default
setting).
In line All digits in the decoded line are in line under the code.
EAN Readline
AP5.4 AP5.6
<> Signs Readline enclosed in "<>" signs or terminated by a ">"-Sign (EAN 13).
Standard Readline without "<>" or ">" signs (default).
1) Assumed that PRINT PARAMETERS > Barcode Multi. = „1“.
Barcodehight
Print
Barcodehight
Layout
1+()x⋅=