Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
29
Print direction
AP5.4 AP5.6
[9] Orientation of the printout „Foot first“ (A) or „Head first“ (B).
Foot first (Default) Orientation of the printout according to [10A].
Head first Orientation of the printout according to [10B]. Mind the following:
¯ Define the „true“ label length (without gap length) in parameter
PRINT PARAMETERS > Material length. If the label gap is wider than 5mm, the
parameter
SYSTEM PARAMETERS > Miss. label tol. must be set to a value more than
zero.
¯ The distance between material base line and the first printable dot is
1 mm. To keep this distance while printing „head first“, the material width
must be calculated as follows::
, with
b
Mat
: Material width
b
Bp
: Backing paper width
AB
Printer
Printout
b
Mat
b
Bp
2mm–=