Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
24
Dottest endless
AP5.4 AP5.6
Dottest for application with endless label stock.
This function prints a pattern which enables trained personnel to check the
adjustment as well as the function of the printhead.
Test pattern
The „Dottest endless“ or „Dottest punched“ prints a pattern consisting of 33
rows filled with vertical lines on the upper label area. All lines have a constant
distance of 4 dot. With every new row, the line pattern is shifted one dot. The
resulting line-pattern repeats every four rows.
The test pattern shows missing dots clearly as white vertical lines running
through the pattern.
The lower label area is filled with testpatterns, which are kept close to those
used by Kyocera. The patterns are useful for printout comparison.
The bars underneath the test pattern allow the adjustment of the different
zero lines.
Dottest punched
AP5.4 AP5.6
Dottest for application with punched material.
P See parameter Dottest endless on page 25.