Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
23
Service Status
AP5.4 AP5.6
Print the Service status report to read about operation time, no. of services,
no. of exchanged parts and other matters of service interest (one page).
Use the parameter
SERVICE FUNCTION > Serv. data reset, to set all the counters to
zero, which are listed on the printout.
[7] Example of a „Service Status“ printout.
P For information on the operational data on the service status printout refer to
paragraph > OPERATION DATA
on page 159.
P For information on the power supply data on the service status printout refer
to paragraph > POWERSUPPLYDATA
on page 164.
P For information on the CPU board data on the service status printout refer to
paragraph > CPU BOARD DATA
on page 165.
P For information on the peripheral driver data on the service status printout
refer to paragraph > MODULE FW VERS.
on page 157.