Service manual
Table Of Contents
- General Information
- Operating the parameter menu
- Overview Parameter Menus
- Alphabetical Parameter List
- PRINT INFO
- PRINT PARAMETERS
- INTERFACE PARA
- SYSTEM PARAMETERS
- Foil end warning
- Foil warn stop
- Print Interpret.
- Character sets
- Character filter
- Light sens. type
- Head-sensor dist.
- Sens. punch-LS
- Foil mode
- Turn-on mode
- Error reprint
- EasyPlug error
- Single job mode
- Head resistance
- Temp. reduction
- Thin line emphas
- Voltage offset
- Miss. label tol.
- Gap detect mode
- Periph. device
- Singlestartquant
- External signal
- Start print mode
- Print contrast
- Ram disk size
- Font downl. area
- Free store size
- Print info mode
- Reprint function
- Language
- Keyboard
- Access authoriz.
- Realtime clock
- I/O BOARD
- DISPENSER PARA
- REWINDER PARA
- MLI PARAMETERS
- SPECIAL FUNCTION
- SERVICE FUNCTION
- SERVICE DATA
03/10 Rev. 5.05-00 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
20
¯ The line width has to be defined as a multiple of the edge length of the
checked pattern!
Internal bar codes The pages titled „Barcode Library“ show print samples of the internal bar
codes (see [4], [8]).
[4] Print sample „Font Status“ / „Font Library“: Bar code listing.
y Onedimensional bar codes are printed with the Easy-Plug command #YB,
see manual Easy-Plug, topic section Description of Commands .
y Two-dimensional bar codes are printed by means of special Easy-Plug
commands:
y GS1 DataBar (formerly RSS) and Composite Component (CC) bar codes are
printed by means of the Easy-Plug command #RSS. The bar code is
Easy-Plug command Bar code
#IDM Data Matrix Code
#MXC Maxi Code
#PDF PDF 417
#CBF Codabar F
#CFN Code 49
#SQR QR Matrix Code
[1] Internal, two-dimensional bar codes.